Pioneer PL-X505 Operating Instructions Manual

STEREO TURNTABLE
PL=-X505
Operating
Instructions
arsae le
Thank you for buying this Pioneer product.
Please read through these operating instructions so you will
know how to operate your model properly. After you have
finished reading the instructions, put them away in a safe
place for future reference.
In some countries or regions, the shape of the power plug
and power outlet may sometimes differ from that shown in
the explanatory drawings. However, the method of con-
necting and operating the unit is the same.
LINE VOLTAGE SELECTOR SWITCH
Only multi-voltage models are provided with this
switch. U.S., Canadian, European, U.K., and Australian
models are not provided with this switch.
The line voltage selector switch is located on the top of the
cabinet of this turntabie. Before your turntable is shipped from
the factory, the switch is set to the power requirements of the
turntable's destination. Check that it is set properly before
plugging the power cord into the outlet. If the voltage is not
WARNING: to prevent Fine OR SHOCK HAZARD,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
IMPORTANT NOTICE
[For U.S. and Canadian models]
The serial number for this equipment is located on the rear
panel. Please write this serial number on your enclosed war-
ranty card and keep in a secure area. This is for your security.
"This product is manufactured to comply with the radio in-
terference requirements of EEC Directive 76/889/EEC and
82/499/ EEC."
properly set or if you move to an area where the voltage re-
quirements differ, adjust the selector switch as follows:
@ Use a medium-sized screwdriver. Insert the tip of the
screwdriver into the groove of the selector switch and
turn it so that the power voltage marking of your area
Points to the arrow.
YQ PIONEER'