When An Error Message Appears On The Display - Brother TZe P-Touch PT-D400VP User Manual

Table of Contents

Advertisement

When an error message appears on the display

When an error message appears on the display, follow the directions
provided below.
Message
Check # of Digits
Entered!
Cutter Error!
Length Limit!
Text Too High!
Text
Too Long!
System Error XX
The number of digits entered in the bar code data does
not match the number of digits set in the bar code
parameters. Enter the correct number of digits.
The tape cutter has been closed when you tried to print or
feed tape. Turn the P-touch labeler off and then on again
before continuing. When tape is tangled in the cutter,
remove the tape.
The length of the label to be printed using the text entered
is longer than 39.37" (1 m). Edit the text so that the length
of the label is less than 39.37" (1 m).
The text size is too large.
The length of the label to be printed using the text entered
is longer than the length setting. Edit the text to fit within
the set length or change the length setting.
Please contact Brother customer service.
TROUBLESHOOTING
Cause/Remedy
When an error message appears on the display
29

Advertisement

Table of Contents
loading

Table of Contents