Advertisement
Mechanical Parts
Motor circuit board
Motor
@)
@
Motor
Capstan belt
tA
t
rs
it
=
= lp
te}
°
fe}
Take up disc
= 0
ce}
ra
©
CSM
i
vi
©
=A
arm ass'y
ol
Be careful not to stain the belt.
When replace the motor, replace it's
circuit board as same time.
Be careful no to stain the belt.
When replace the flywheel, don't
forget to insert a nylon washer to
it's shaft.
Fig. 6
Mecha-ass'y
Remove the cassette cover, head cover
and bottom cover.
@
chassis.
Motor
. Remove the take up belt.
. Remove the capstan belt.
. Disconnect 2 wires of motor circuit
board ass'y.
. Remove 3 screws and 3 washers fasten-
Q)
ing the motor.
Pinch roller arm assy
1. Remove "E" ring holding the pinch
@)
roller arm ass'y.
Take up disc
. Remove the counter belt.
. Remove "E" ring holding the take up
disc.
. Pull off the disc from the shaft.
Supply disc
1. Remove "E" ring holding the supply
6)
2. Pull off the disc from the shaft.
Remove 4 screws fastening the macha-
Flywheel
. Remove the take up belt.
. Remove the capstan belt.
. Remove 2 screws fastening the fly-
wheel holder.
. Pull off the flywheel.
. Remove spring on the arm ass'y.
disc.
NOTE;
Don't dirty, slippery and undue run-out the capstan belt and counter belt.
CD-1770/A/H/C/E
ay
a
No. 4144
Advertisement
