Panasonic ER412 Operating Instructions page 3

Parts identification
(See fig. 1)
(A) Protective cap
Outer blade
© Outer blade frame
(D) Inner blade
E Joint
On/off switch
Slide the switch upward to turn the
trimmer on.
@ Body
(H) Battery cover
Replacing battery
(See fig. 2)
Turn the battery cover counter clockwise
and match the line (a) with (b) and pull to
remove. Insert one AA battery. To
replace the battery cover, reverse the
above procedure.
Using your trimmer
Turn on the switch and carefully insert
the tip of the outer blade into your nostril
or an ear hole to trim the nose and ear
hairs.
Maintenance
Be sure that the switch is turned off
before removing, replacing or cleaning
the blades.
To remove the outer blade frame, turn it
and match the line ©) with @) and pull
upward. (See fig. 3)
Detach the inner blade from the outer
blade. Wipe the blades with a tissue to
remove any cut hairs, dust, etc.
THE WHOLE UNIT CAN BE WASHED
IN WATER.
DO NOT USE BOILED WATER.
Next, put the inner blade back into the
outer blade. To replace the outer blade
frame to the body, match the mark (©)
with (9), and turn clockwise until it
clicks in.
Caution
Do not insert the device further into your
nostrii or an ear hole than the narrow tip
on the outer blade. Also, do not press
the trimmer forcefully into your nostril, or
an ear hole.
Do not attempt to use the device if the
outer blade frame or blades are
deformed or damaged, as injury to your
nostril or an ear hole may occur.
This trimmer is designed only for cutting
nose or ear hairs. Do not attempt to use
it for any other purpose. The blades
have been precision manufactured. Do
not subject them to excessive force,
impact, etc.
Be sure that the switch is turned off
before attempting to clean the blades.
If used once a week for approx. 1 min. at
a time, the life of the blades is approx.
3 years.
READ ALL INSTRUCTIONS
BEFORE USE.
Service : Assistance : Accessories
800-338-0552
panasonic.com/personalcare