Craftsman PRO 247.888740 Operator's Manual page 11

10. Finish securing chute control head to chute support bracket with wing nut,
and clevis pin and bow-tie cotter pin removed in Step 2. Do not overtighten.
See Figure 10.
11. Check that all cables are properly routed through the cable guide on the
engine. See Figure 11.
NOTE: If the chute control is not assembled correctly it will not move freely
nor will it move fully to the right and left.
Set-Up
Shear Pins
Holes are located in the plastic dash panel for convenient shear pin storage. See
Figure 12. Refer to the Operation section for more information regarding shear pin
replacement.
NOTE: If the extra shear pins are not already assembled in the handle panel, they
can be found in the manual bag.
Figure 10
ASSEMBLY
11
Figure 11
Figure 12