Table of Contents
Advertisement
}
i
|
Systom connoctions
Make connection as shown below. When connecting the related system components, refer alse to the instruction
manuals of the related components.
Do not plug in the power lead until all connections are completed.
KENWOOD Integrated amplifier
E
theres
Shepe of AC
Unit destination
outlet
ne
Other countries
(A-76, A-66)
Audio cord
Unplug the shorting pins
from the ADAPTOR
jacks and connect the
component to these jacks.
UNSWATCHED
TOTAL 100M MAX.
'AC voltage selector switch
(Except for some areas)
To "SWITCHED" AC outlet
on the amplifier rear panel
System control teminals
For the connetion of the SYSTEM
CONTROL terminals and power
cords, refer to connection diagram
of the main system.
s
System control connection
x
O
i
wihenainpingeine ie eared
When connected to the main system, system operation
c
J
such as remote control is made possible. For details,
t
refer to the instruction manual of the main system.
ae
If your amplifier or receiver is not equipped with the
SYSTEM CONTROL terminals, do not connect anything
Push
to any SYSTEM CONTROL terminal.
Insert securely until it clicks
Do not connect the unit in any system configuration
Other shan specitied:
* Be sure to insert the system control cord plugs fully into the
SYSTEM CONTROL terminals.
*\f the system control cord and audio cords are not connected
properly, the automatic system governing remote control and
system functions will not operate.
Notes:
1. Connect all cords firmly. lf connections are loose, there could be loss of sound or noise produced.
2..When
plugging and unplugging connection cords, be sure to first remove the power cord from the AC outlet. Plugging/unplugging
connection cords without removal of the power cord can cause malfunctions or damage to the unit.
3. Do not connect up a power source which is larger than that indicated on the socket at the rear of the unit.
6 GE-560 (En)
Advertisement
Table of Contents
