Split Point Change; Page Memory - Yamaha PORTATONE PSR-500M Owner's Manual

Table of Contents

Advertisement

Press the TEMPO [A] button to increase the tempo, or
the TEMPO [W] button to decrease the tempo. The se-
lected tempo will be displayed on the MULTI DISPLAY
(in quarter-note beats per minute) while the TEMPO [A]
or [V] button is pressed, and for approximately 2 seconds
after either TEMPO button is released.
The available tempo range is from 40 to 240 beats per
minute. Each accompaniment style has a different "de-
fault" tempo which is automatically set whenever a new
style is selected (but not when a new style is selected
while the accompaniment is playing). The default tempo
for the currently selected accompaniment style can be
recalled at any time by pressing both the TEMPO [A] and
[V] buttons at the same time. .
€. SPLIT POINT CHANGE
Separate split points can be set for the SPLIT, FIN-
GERED, and SINGLE FINGER modes. The default split
point settings are as follows:
* SPLIT mode:
C#3
* SINGLE FINGER mode: D2
* FINGERED mode:
G2
The split point for each mode can be set to any other
key while that mode is selected by pressing the desired
split-point key while holding the [SPLIT POINT
CHANGE] button.
SPLIT POINT
CHANGE
>
The split point is shown on the MULTI DISPLAY for
as long as the [SPLIT POINT CHANGE] button is held.
The C3 key, for example, would be displayed as "c 3".
F#2 would be displayed as "F2". The sharp is indicated
by the lit bar between the "F" and the "2."
узын
oet __ млрэмюн ceu
паши 4 зза
Zi
e
>
с
Э
а
ТУТ
>.
SmE
SPuTvOCK
ВРАГ
и
sme sarvoct
sm
sout voce
BEAT
Сз
Fia
The SPLIT, SINGLE FINGER, and FINGERED mode
split points are retained in memory and will be recalled
whenever the corresponding mode is selected.
Note that the split-point key is included in the right-
hand section of the keyboard.
* When this parameter has been changed, be sure to store the
new data to a PAGE MEMORY (see next paragraph). If this is
not done the newly selected data will be lost when a different
PAGE MEMORY is selected.
FEATURE REFERENCE (OvERALL CONTROL)
€ PAGE MEMORY
The PAGE MEMORY can be used to store 4 complete
sets of panel settings (including the contents of the SONG
MEMORY and MULTI PAD features) that can then be
recalled simply by pressing a single button.
When the power is initially turned on the previously
selected "PAGE" is automatically selected and its indica-
tor will light. If any changes are then made to the panel
settings the PAGE indicator will flash, indicating that
changes have been made. If the same PAGE button is then
pressed the original PAGE settings will be recalled and
the indicator will light continuously again.
The following panel settings are stored by the PAGE
MEMORY:
* Currently selected voice(s).
* MULTI PAD contents.
* SONG MEMORY contents.
* VOICE MEMORY contents.
* VOICE section parameter settings (Auto Harmony, Reverb
Depth, Volume, Octave, Pan, MIDI Out Channel, Dual).
* CUSTOM ACCOMPANIMENT contents.
* Currently selected STYLE.
* Currently selected chord voice when accompaniment stopped.
* ORCHESTRATION settings.
* ACCOMPANIMENT CONTROL status.
*
MODE.
* ACCOMP. VOLUME.
* TUNE.
* TRANSPOSE.
* TEMPO.
* PITCH BEND RANGE.
* DSP
* MIDI RECEIVE CHANNEL/CLOCK.
* The MIDI MODE setting is not recorded by the PAGE MEMORY.
MIDI MODE is reset to *00" whenever the power is turned on or
a different PAGE is selected.
Recording
Make the desired panel settings, then press one of the
PAGE MEMORY buttons while holding the [RECORD]
button. The corresponding indicator will light indicating
that the data has been memorized. All previous data in the
selected PAGE will be erased.
ers MEMORY
RECORD
eii
FAGE 2
snes
Sr
MID! BULK DUMP
/? ^N
* The PAGE MEMORY cannot be recorded while any automatic
playback feature or any recording function is running (AUTO
ACCOMPANIMENT play; SONG MEMORY record/play/play
ready; MULTI PAD record/play; CUSTOM ACCOMPANIMENT
record/play, DEMO play).

Advertisement

Table of Contents
loading

Table of Contents