Hitachi BD-90YFVEM Instruction Manual page 41

• Some meshed laundry such as tulle may
foam too much because of their texture.
>>> Use smaller amounts of detergent for
this type of item.
• Detergent was put in the wrong compart-
ment. >>> Make sure you place the de-
tergent in the appropriate compartment.
• Softener is being taken early by the
product. >>> There may be problem in the
valves or in the detergent drawer. Call the
Authorised Service Agent.
Foam is overflowing from the detergent
drawer.
• Too much detergent is used. >>> Mix 1
tablespoonful softener and ½ l water and
pour into the main wash compartment of
the detergent drawer. >>> Put detergent
into the product suitable for the pro-
grammes and maximum loads indicated
in the "Programme and consumption
table". When you use additional chemic-
als (stain removers, bleaches and etc.),
reduce the amount of detergent.
Laundry remains wet at the end of the
programme. (*)
• Excessive foam has occurred and auto-
matic foam absorption system has been
activated due to too much detergent us-
age. >>> Use recommended amount of
detergent.
(*) The product does not switch to spinning
step when the laundry is not evenly distrib-
uted in the drum to prevent any damage to
the product and to its surrounding environ-
ment. Laundry should be rearranged and re-
spun.
(**) Regular drum cleaning is not applied.
Clean the drum regularly. See Cleaning the
Loading Door and the Drum [} 35]
If you cannot eliminate the problem
although you follow the instructions
in this section, consult your dealer
or the Authorised Service Agent.
Never try to repair a nonfunctional
product yourself.
Check the HomeWhiz section for
the relevant troubleshooting in-
formation.
EN / 41