Dell OptiPlex 7040-Small Form Factor Owner's Manual page 43

Table 16. Maintenance (continued)
Option
Dell Development Configuration Allows you to turn on/off certain features to control the BIOS. This option is disabled by
BIOS Downgrade
Data Wipe
BIOS recovery
Table 17. Cloud desktop
Option
Server Lookup Method
Server Name
Server IP Address
Server port
Client Address Method
Client IP address
Client Subnet Mask
Client Gateway
DNS IP Address
Domain Name
Advanced
Table 18. System logs
Option
BIOS Events
Table 19. Advanced configurations
Option
ASPM
Description
default.
Allows you to control flashing of the system firmware to the previous versions. This option is
enabled by default.
NOTE: If this option is not selected, the flashing of the system firmware to the previous
versions is blocked.
Allows you to securely erase the data from all the available internal storages, such as HDD,
SSD, mSATA, and eMMC. This option is disabled by default.
Allows you to recover the corrupted BIOS conditions from the recovery files on the primary
hard drive or an external USB key.
Description
Allows you to specify how the cloud desktop software will lookup server addresses.
● Static
● DNS (Default)
Allows you to specify the name of the server
Specifies the primary static IP address of the cloud desktop server. The default IP address is
255.255.255.255
Specifies the primary port of the cloud desktop. The default setting is 06910.
Specifies how the client will obtain the IP address.
● Static IP
● DHCP (Default)
Specifies the static IP address of the client. The default IP address is 255.255.255.255
Specifies the subnet mask address of the client. The default IP address is 255.255.255.255
Specifies the gateway address of the client. The default IP address is 255.255.255.255
Specifies the DNS IP address of the client. The default IP address is 255.255.255.255
Specifies the domain name of the client.
Allows you to turn on the Verbose mode for advanced debugging. This option is disabled by
default.
Description
Displays the system event log and allows you to:
● Clear Log
● Mark all Entries
Description
Allows you to activate the state power management.
● Auto (Default)
● Disabled
● L1 Only
System Setup 43