Installing the LED Light Kit
Note:
For installation assistance, contact an
Authorized Service Dealer.
1.
Install the light bracket onto the front of the
machine using the 2 hex-washer-head thread
forming screws (5/16 x 3/4 inch).
2.
Install the light to the light bracket using the 2
hex-washer-head screws.
3.
Connect the wire harness to the back of the
lights and secure the harness to the front frame
rail using the harness clip.
Figure 1
Figure 2
1. Harness clip
4.
Route the wire harness along the right frame
rail, while securing the harness clips to the rail.
g468945
5.
Cut the cable tie securing the auxiliary connector
g468946
off the main harness and remove the auxiliary
end plug.
6.
Connect the light harness to the auxiliary
connector.
7.
Secure the kit wire harness to the machine wire
harness using the cable tie.
8.
Electric machines only: install the batteries.
2
Figure 3
Figure 4
g468947
g468948