Kenwood FG-273 Service Manual page 5

SAFETY
Line voltage
Power cord"
North American
120 volt/60 Hz
Rated 15 amp
(12 amp max; NEC)
Line fuse . :
The fuse holder is located. on the. rear r panel and contains
the line fuse.. Verify that.the proper fuse is installed by
replacing the line fuse.
Voltage conversion
_ This instrument may be operated from either a 100 V to
240 V, 50/60 Hz power source. Use the following pro-
cedure to change from.100 to 240 volt operation or vice
versa.
1. Replace fuse FS1 with a fuse of appropriate value, 0.3 A
slow-blow type for 100 VAC to 120 VAC operation,
0.2 A fast-blow for 220 VAC to 240 VAC operation.
2. Reinsert it for appropriate voltage range.
3. When performing the reinsertion of fuse holder for the
voltage conversion, the appropriate power cord should
be used. (See Fig. 1.)
0.3 A, 250 V
Slow blow
6x30 mm
Universal Europe
220 voilt/50 Hz
Rated 16 amp
' Factory installed Line cord Parts No. for power
instrument fuse plug fuse cord and plate |
Cord:
E30-1820-05
0.2 A, 250 V
Fast blow
6x 30 mm
Cord:
E30-1819-05
U.K.
240 volt/50 Hz
Rated 13 amp
0.2 A, 250 V
Fast blow
6x30 mm
Australian
240 voit/50 Hz
Rated 10 amp
0.2 A, 250 V
Fast blow
6 x 30 mm
Cord:
E30-1821-05
North American
240 volt/60 Hz
Rated 15 amp
(12 amp max; NEC)
0.2 A, 250 V
Fast blow
6x30 mm
Switzerland
240 volt/50 Hz
Rated 10 amp
Fig. 1 Power Input Voltage Configuration
0.2 A, 250 V
Fast blow
6x30 mm