Advertisement
INTRODUCTION
Before
leaving
the fa.ctory each oven is carefully
checked.
0
I
It must however,
be Installed
and used correctly.
~
Oespite all the steps taken to make the oven safe, the safety is dependent
on the correct
installation
and the fact the user
'-
-"!
understands
how to use and maintain
the oven.
The information
in this section
should be used as areminder
that the oven is safe and that anyone who uses it must first
read the instructions
tor use in order to be able to use the oven correctly
and obtain the best results.
1
SAFETY
\
To avoid
injury to yourself
and damage
to the appliance
always
work to the following
rules when servicing
an oven.
.Always
disconnect
the plug from the mains before starting
work.
If there is no plug
switch-off
the electricity
supply at the control
box.
.When
you have finished
servicing
an oven before you reconnect
it to the mains, make sure that:
-all
the internat
connections
are correct
-the
wires
are insulated
and not touching
the door or the cabinet
or anything
sharp
-all
the earth connections
are electrically
and mechanically
sound
~
-do
not modify
or anyway
interfere
with the safety devices
built-in
to the oven
Ji
-make
sure
that each
replacement
part you use conforms
to the manufacturer's
specifications
.00
not start arepair
if you have any doubt as to your ability to complete
it.
CAUTION -MICROWAVE
RADIATION
PERSONNEL SHOULD
NOT BE EXPOSED TO THE MICROWAVE ENERGY WHICH MAY RADIATE FROM THE
MAGNETRON, WAVEGUIDE OR ANTENNA IFTHEY ARE IMPROPERLY USED OR CONNECTED. ALL INPUTAND OUT-
PUT MICROWAVE CONNECTIONS, WAVEGUIDES, FLANGES AND GASKETS MUST BE SECURE.
NEVER OPERATE THE DEVICE WITHOUT A MICROWAVE ENERGY ABSORBING LOAD ATTACHED.
NEVER LOOK INTO AN OPEN WAVEGUIDE OR ANTEN NA WHILE THE DEVICE IS ENERGIZED.
NEVER OPERATE AN OVEN WITH CABINET OFF WITHOUT MEASURING THE MICROWAVE LEAKAGE AROUND
MAGNETRON AND VISIBLE MICROWAVE CONNECTIONS (WELDING JOINTS).
')
00 not operate
the oven if the following
conditions
exist:
-The
door does not close firmly
against the door support because
of the door being warped
or the hinges damaged.
-The
door trims or seals are damaged.
-If
there is any visible
damage
to the oven.
-If
the door does
not close
properly.
Avoid operating
the oven if known components
in the interlock system,
oven door or microwave
generating
assembly
are
known defective.
They must be replaced.
,
WARNING -HIGH VOLTAGE
IT IS POSSIBLE TO COME IN CONTACT WITH LETHAL HIGH VaL TAGE WHEN WORKING WITH HV TRANSFORMER, HV
.
CAPACITOR, AND MAGNETRON.
THEREFORE NEVER TRY TO MEASURE THE HIGH VOLTAGE. ALWAYS TAKE UTMOST CARE WHEN PERFORMING
ELECTRIC MEASUREMENTS INSIDE THE OVEN.
J
""
":1
c;
l.
.
Advertisement
