Setting The Channel Selection Method And Power-Up Conditions (Set Up 4) - System Configuration Menu; Overview; Structure Of The System Configuration Menu [C4] - Sony HD Trinitron HDM-20E1J Operation Manual

Setting the Channel Selection Method and Power-Up
Conditions (SET UP 4) — SYSTEM CONFIGURATION Menu

Overview

The SYSTEM CONFIGURATION menu is used for
the following settings:
• Channel number entry method
The two ways in which the ten-key pad can be used
to enter channel numbers are as follows:
(In the explanation below, x and y represent any digit
between 1 and 9.)
DIRECT mode: When selecting a number from 1 to
9, press the x button to display channel x. When
selecting a number from 10 to 99, press the 0, x, and
y buttons to display channel xy (a two-digit channel
number). This mode is selected at the shipping.
10KEY mode: When the x button is pressed
followed by the ENTER button, the monitor displays
channel x. When the x buttons is pressed, followed by
the y and ENTER buttons, the monitor displays
channel xy (a two-digit channel number).
When multiple monitors are connected by a serial
remote connection, this setting will be common to all
the monitors. It is not possible to change the setting
for individual monitors.
• Power-up condition
This menu sets the condition of the monitor when the
MAIN POWER switch on the rear panel is switched
on.
ON: Standby mode
OFF: Operation mode
Structure of the SYSTEM CONFIGURATION Menu
Main Menu Level 1
SET UP C
INPUT CONFIGURATION [C1]
REMOTE [C2]
PASSWORD [C3]
SYSTEM CONFIGURATION [C4]
ON SCREEN SET [C5]
ALIGNMENT [C6]
EXTEND MENU [C7]
• Power-up input channel
LAST: Set the channel to the channel that was
selected at the time the power was last turned off.
CH xx: Set the channel to a specific channel number.
• Time from power-up until degauss
If several monitors are turned on at the same time and
all start degaussing at the same time, there will be a
very large current draw on the power supply for a few
moments. To prevent this, the delay time between
power-up and degaussing can be set for each monitor
independently.
• Setting of the contrast and brightness after
adjusting the white balance or auto adjustment of
the CONTROL PRESET ADJ menu
ON: The contrast and brightness are set to the
adjusted value before adjusting the white balance.
OFF: The contrast and brightness are set to the center
value (1000) after adjusting the white balance.
• Assigning shortcut to the menu to the [F2] key
Assigns the shortcut to the MANUAL menu of the
COLOR TEMP ADJ menu to the [F2] key. This
allows you to jump directly to the MANUAL menu
corresponding to the color temperature set to the
currently displayed image (STD/COL 1/COL 2/CH
SET).
ON: Assigns the shortcut to the MANUAL menu of
the COLOR TEMP ADJ menu.
OFF: Does not assign the shortcut to the MANUAL
menu of the COLOR TEMP ADJ menu.
Level 2
INPUT SELECT
STANDBY MODE
DEFAULT CH
DEGAUSS DELAY
CONT/BRT HOLD
COL TEMP SHORT-CUT
[C4]
35 (E)