Husqvarna DC 900 Operator's Manual page 16

To clean the filter in the water
separator
CAUTION:
washer to clean the filter. Do not hit the filter
with force to clean it.
1. Remove the filter in the water separator. Refer to
replace the filter in the water separator on page 16 .
2. Clean the filter with warm water.
3. Dry the filter with pressurized air.
4. Install the filter. Refer to
water separator on page 16 .
To replace the filter in the water separator
1. Stop the product. Refer to
page 12 .
2. Remove the bowl of the water separator (A).
3. Replace the filter of the water separator (B).
4. Install the bowl of the water separator (A).
To clean the primary filters
WARNING:
intakes when the pulse cleaning cycle runs.
If the air intakes are not closed, dust can
come in to the air. The dust particles are
dangerous to your health.
16
Do not use a high-pressure
To replace the filter in the
To stop the product on
B
A
Always close off the air
1. Start the compressor.
To
2. Start the motor for the rotating valves.
3. Keep the air compressor on for 30 minutes while
the product is not in operation. Pressurized air goes
through the primary filters and cleans them.
To replace the primary filters
WARNING:
protective equipment when you replace the
primary filters. Refer to
equipment on page 6 .
There are 20 primary filters in the product. Replace all
filters at the same time.
1. Stop the product. Refer to
page 12 .
Always use personal
Personal protective
To stop the product on
2154 - 002 - 25.10.2023