Disassembly; Disassembly Flow; Panel (Side) L/R Assy - Sony UDA-1 Service Manual

UDA-1
• This set can be disassembled in the order shown below.
2-1.

DISASSEMBLY FLOW

SET

2-2. PANEL (SIDE) L/R ASSY

(Page 6)
2-3. PANEL (AL) BLOCK, FUSE (F120)
(Page 7)
2-4. DCDC BOARD
(Page 8)
2-5. AMP BOARD-1
(Page 9)
2-6. AMP BOARD-2
(Page 10)
Note: Follow the disassembly procedure in the numerical order given.
2-2. PANEL (SIDE) L/R ASSY
1 screw
(for SILVER: B3 4)/
(for BLACK: B3 5)
5 teflon tape
(sub material)
3 three claws
6 panel (side) L assy
3 two claws
3 two claws
6
SECTION 2

DISASSEMBLY

2-7. SPTM BOARD
(Page 10)
2-8. DIGITAL BOARD BLOCK
(Page 11)
2-9. DIGITAL BOARD
(Page 12)
5 teflon tape
(sub material)
2 Slide the panel
(side) R assy in the
direction of an arrow
and remove the claws.
2 Slide the panel
(side) L assy in the
direction of an arrow
and remove the claws.
4 tape
2-10. DAC BOARD
(Page 12)
2-11. AC INLET (2P) (AC1)
(Page 13)
2-12. PRIMARY BOARD
(Page 13)
1 screw
(for SILVER: B3
(for BLACK: B3
Note: Please spread a sheet under
– Rear bottom view –
4)/
5)
3 three claws
6 panel (side) R assy
3 two claws
3 two claws
4 tape
a unit not to injure top panel.