Advertisement
To stop the product
1. Move the throttle control to the idle speed position.
2. Set the ON/OFF switch to "OFF". The engine stops.
3. Move the fuel valve to the "OFF" position.
To do if the engine does not start
If the engine does not start and white smoke shows, do
the procedure that follows.
1. Set the throttle control to the stop position.
2. Slowly pull and release the starter rope handle 5
times.
3. Do the start procedure again.
To operate the product
CAUTION: Always operate the product
forward and at full throttle. Lower engine
speed and rearward movement prevent
correct function of the eccentric element and
can cause product failure.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
General product maintenance
Make sure that there are no fuel or oil leaks.
Clean the product.
Make sure that nuts and screws are tightened.
Examine the throttle control and choke control for damage.
Make sure that the throttle control and the choke control can move
smoothly.
Do a check of the ON/OFF switch.
Lubricate the controls and linkages.
Examine the vibration damping units for damage.
Examine the V-belt for damages.
Replace the V-belt.
Replace the 4 vibration damping units on the ground plate.
10
1. Make sure that the throttle control is set to full
throttle.
2. Carefully push the product forward.
3. To change direction, turn the product around.
Maintenance
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = Refer to the engine manual for instructions.
CAUTION: Do not push the product
down. Too much pressure can cause
unsatisfactory result.
Before use,
Weekly,
each 10 h
each 100 h
*
X
*
*
*
*
*
X
X
1652 - 001 - 03.05.2021
Yearly, each
150 h
*
X
Advertisement
