Advertisement
Quick Links
54in Recycler Kit
TimeCutter® MX 5475 or 5475C Riding Mower
Model No. 161-4520
Installation
Preparing the Machine
1. Park the machine on a level surface.
2. Disengage the blade-control switch.
3. Move the motion-control levers outward to the
4. Engage the parking brake.
5. Shut off the machine and remove the key.
6. Wait for all moving parts to stop.
7. Allow machine components to cool.
8. Remove the battery packs from the machine.
9. For easier access, raise the front of the machine and support it using jackstands rated
for your machine.
Mechanical or hydraulic jacks may fail to support the machine and cause serious
injury.
Use jack stands when supporting the machine.
© 2023—The Toro
®
Company
8111 Lyndale Ave So
Bloomington, MN 55044
WARNING
Register at www.Toro.com
Installation Instructions
position.
NEUTRAL
Original Instructions (EN)
Printed in the USA
All rights reserved
3465-262A
*3465-262* A
Advertisement
Related Manuals for Toro 161-4520
Summary of Contents for Toro 161-4520
- Page 1 3465-262A 54in Recycler Kit TimeCutter® MX 5475 or 5475C Riding Mower Model No. 161-4520 Installation Instructions Installation Preparing the Machine 1. Park the machine on a level surface. 2. Disengage the blade-control switch. 3. Move the motion-control levers outward to the position.
- Page 2 Preparing the Mower Deck 1. Remove the nut securing the cutoff baffle to the deck and remove the cutoff baffle. Note: Retain the baffle for converting back to side discharge. G463426 2. Reinstall the previously removed nut onto the discharge rod. 3.
- Page 3 Installing the Right Baffle Parts Required Right baffle Bolt (5/16 x 3/4 inch) Nut (5/16 inch) 1. Install the right baffle using 3 nuts (5/16 inch) as shown. Tighten the fasteners by hand. G463493 2. Secure the rear wall of the right baffle to the mower deck using the bolt (5/16 inch x 3/4 inch) and nut (5/16 inch) as shown.
- Page 4 Installing the Left Baffle Parts Required Left baffle Bolt (5/16 x 3/4 inch) Nut (5/16 inch) 1. Install the left baffle using 1 bolt (5/16 x 3/4 inch) and 3 nuts (5/16 inch) as shown G463579 G463659 2. Tighten all fasteners. Page 4 3465-262 A...
- Page 5 Installing the Decal and Kickers Parts Required Decal Kicker 1. Install the decal to the mower deck as shown. G465697 Decal 2. Install the kickers into the deck with the previously removed hardware. G465674 3465-262A Page 5...
- Page 6 Operation Operating Tips Using the High Blade Speed Setting For best mowing and maximum air circulation, operate the blades at the position. Air is HIGH required to thoroughly cut grass clippings, so do not set the height of cut so low as to totally surround the mower in uncut grass.
- Page 7 File down any nicks and sharpen the blades as necessary. If a blade is damaged or worn, replace it immediately with a genuine Toro replacement blade. 3465-262A Page 7...