Table of Contents
Advertisement
| STORING A PROGRAM (PRG and 1-0)
— By programming the changer, you can play up to 30 tracks in any required sequence.
— FULL lights up if you exceed the maximum of 30 tracks.
-- NOT POSSIBLE lights up if you select a non-existent CD number.
~ USE 0-9 lights up if you press >I or él 72 while programming.
e In STOP mode, press PRG (program) 3 to open the memory.
— SELECT DISC lights up and
starts flashing.
e Select the number of the first required CD using DISC SELECT 6 or DISC 6 (on the remote control - CDC926
only).
e Key in the required track numbers of the selected CD using the 1-0 digit buttons 2.
— Every track number you enter in this way will be included immediately in the program.
- The display always shows the number of tracks and the playing time of your program.
e If you wish to store tracks from another CD, you should first enter the number of the CD.
e Press PRG to quit the PROGRAM mode.
e Press PLAY/REPLAY 14 to play the program.
CHECKING THE PROGRAM
(REVIEW)
ERASING A TRACK FROM A PROGRAM
(CLR)
e Press REVIEW 9 prior to, during or after programmed play.
e Press REVIEW 9 before or after programmed play (STOP
— REV lights up and all CD and track numbers appear in the
mode).
programmed sequence on the display.
— All CD and track numbers appear in the programmed
- Under TRACK TIME you will see the playing time of each
sequence on the display.
track.
e Press CLR (clear) 4 as soon as the number you wish to erase
appears.
— The number has now been erased.
— The display shows the remaining number of tracks and the
remaining programme time for a few seconds.
NO PROG will light up if no track numbers have been stored.
With REVIEW you can proceed more rapidly to the next block
of information.
NO PROG will light up if no track numbers have yet been
PLAYING THE PROGRAM (PLAY/REPLAY)
_—_ —
stored and if you have not pressed REVIEW first before
e Press PLAY/REPLAY 14.
cancelling.
— Playback starts with the first number of the program.
The EDIT 70, PRG 3 and CLR 4 and PEAK SEARCH 79 buttons
cannot be used during programmed play.
Searching for a particular passage is only possible within the
track being played.
ERASING A PROGRAM (STOP/CP, CLR or OPEN/CLOSE)
In PLAY mode:
e Press OPEN/CLOSE 7 or STOP/CP 13 (twice).
In STOP mode:
e Press OPEN/CLOSE 7, CLR 4or STOP/CP 13
— The program has now been erased.
13
ee
meee e o
rr
ee
en
ee
er
ee
---
—
—-——-
=
—
-———
e—-
——— —=—=
me re
Advertisement
Table of Contents
