Changing Front Panels.16-17 - KitchenAid 4KUCS181T Use And Care Manual

Changing Front Panels
Your Compactor comes equipped with two
reversible front panels painted Almond/
White and Harvest Wheat/Onyx Black,
providing four front panel colors from which
to choose.
Additional Compactor Front Panels are
available in Fresh Avocado/Coffee or
Stainless Steel from your KitchenAid dealer or
local service facility
If you want to change the color of the
panels, follow these steps:
Electrical Shock Hazard
Disconnect electrical power supply to
compactor before changing panels.
Failure to do so could result in
electrical shock or personal injury.
Litter Bin* Door Panels:
1 Disconnect power supply to compactor
before changing panel.
2. Open Litter Bin Door and remove three
retaining screws in door handle; remove
handle.
3. Slide panel out. HANDLE CAREFULLY SO
THE PANELS WILL NOT BE SCRATCHED
OR BENT. Replace panel so the desired
color is exposed.
4. Replace the handle and screws.
Drawer Panels — Recessed Unit:
2. Be sure ram is in "up" position.
3. Open drawer to fully extended position.
4. Remove drawer retaining screws (A)
which hold drawer to track assembly.
Carefully remove drawer from track
assembly, making sure that full weight of
drawer is supported at all times.
5. Tilt drawer on its back.
6. Remove three retaining screws in lower
drawer trim. Remove loosened trim. Slide
panel out. HANDLE CAREFULLY SO THE
PANELS WILL NOT BE SCRATCHED OR
BENT. Replace panel so desired color is
exposed, making sure that handle trim
bezel is placed into slots in panels.
7. Replace trim and screws.
8. Re-attach drawer to track and replace
drawer retaining screws.
16