Troubleshooting; Cleaning And Maintenance; Technical Data - Haier I-Master 5 Series User Manual

• Alternatively, the trigger button may be
pressed down for short periods of time to
produce a pulsing action.
• This can be used to avoid over processing
food. Operate the chopper until the
desired result is achieved.
• Loosen the trigger button firmly to switch
off, take out the blades first, then pour out
the food.
Do not run the chopper attachment continuously
for longer than 30 seconds. Leave to cool for 1
minute in between each 30 second operation.
Recipe Example: Butter/ Honey
200g Butter(2 cm cubes frozen) / 300g
Honey(Chilled)
Chop at high speed in a chopper bowl for 5
seconds.
Reverse the above procedure to disassemble
the unit.
5. Cleaning & Maintenance
CAUTION: Make sure that the main body is
unplugged from the mains power supply and
that the blades have stopped turning before
attaching or removing any accessory.
Disassemble all parts before washing.
DO NOT immerse the main body, gear box of
whisk , gear box of potato masher and gear box
of chopper cover into water or any other liquid,
clean with a damp sponge or cloth and wipe dry.
The metal leg can be rinsed under running
water.
Handle the blades with care they are extremely
sharp.
Following parts/tools you could put
them in dishwasher to clean.
[Fig. 14]
• Beaker
• Whisk leg*
• Blade of Potato Masher*
• Upper blade*
• Blade shaft*
• Glass jug*
• Non-slip pad
All parts must be completely cleaned and dry
before being stored.
Assemble the appliance with the blades,
chopper accessories and main body in position.
Store the appliance in the box or in a clean, dry
place well out of the reach of children.
* For certain model only.

6. Troubleshooting

1. Hand blender starts to slow or labor during
processing.
Check that the bottom of motor head is clean
and there is no food blocking connection when
placing on containers or too much food in the
container.
If the unit has overheated, unplug and wait
approximately 10 minutes before using again.
2. Excessive splashing during processing
Select a lower speed initially and increase as the
mixture thickens.
Select an appropriately sized container. Place
the blades into the food before switching on.
3. Main body gets hot during operation.
Allow the unit to cool fully before using again.

7. Technical data

Electrical connection
Power
8. Important information
Haier Spares and Consumables
Always replace parts with genuine Haier spares.
These are available from your local Haier dealer
or direct from Haier. When ordering parts always
quote your model number.
Quality
Haier's factories have been independently
assessed for quality. Our products are made
using a quality system which meets the
requirements of ISO 9001.
Your Guarantee
The guarantee conditions for this appliance are
as defined by our representative in the country
in which it is sold. Details regarding these
conditions can be obtained from the dealer from
whom the appliance was purchased. The bill of
sale or receipt must be produced when making
any claim under the terms of this guarantee.
5
220-240V~50/60Hz
1000W
GB