Table of Contents
Advertisement
door locked indicator
indicator of the running phase
flashes.
• The drum still turns at regular
intervals to prevent the creases in the
laundry.
• The door stays locked.
• You must drain the water to open the
door:
1. If necessary, touch the Spin button to
decrease the spin speed proposed
by the appliance.
2. Touch the Start/Pause
• If you have set
drains the water and spins.
• If you have set
only drains the water.
The option indicator
while the indicator
goes off.
3. When the programme is completed
and the door locked indicator
goes off, you can open the door.
4. Press the On/Off
seconds to deactivate the appliance.
In any case, the appliance
empties the water out
automatically after
approximately 18 hours.
14. DAILY USE - WASHING & DRYING
WARNING!
Refer to Safety chapters.
This appliance is an
automatic washer dryer.
14.1 NON-STOP programme -
Washing and drying mode
Not all programmes are
compatible with drying
mode.
In some washing programmes, you can
combine WASH and DRY mode for
running a complete wash&dry
programme. Proceed as follows:
. The
button:
, the appliance
, the appliance
or
goes off,
flashes and then
button a few
13.14 Stand-by option
The Stand-by function automatically
deactivates the appliance to decrease
the energy consumption when:
• You do not use the appliance for 5
minutes before you touch the Start/
Pause
button.
Press the On/Off
the appliance again.
• After 5 minutes from the end of the
washing programme
Press the On/Off
the appliance again.
The display shows the end of the last
set programme.
Turn the programme dial to set a new
cycle.
If you set a programme or an
option that ends with water
in the drum, the Stand-by
function doesn't deactivate
the appliance to remind you
to drain the water.
If the Wi-Fi Always On
function is active, only the
indicator
intermittently.
1. Press the On/Off
seconds to activate the appliance.
2. Load the laundry one item at a time.
3. Put the detergent and the additives in
the appropriate compartment.
4. Turn the programme dial to the
washing programme. The display
shows the default temperature and
spin. If necessary, change them
according to your laundry. The
display also shows the maximum
recommended load for washing
phase.
5. Set the desired options, if there are
available.
6. Touch the DRY mode button once to
activate also the drying function. The
leds of the WASH and DRY
indicators come on. The indicators
ENGLISH
45
button to activate
button to activate
goes on and off
button for some
Advertisement
Table of Contents
