Electrolux EI30BM55HWB Installation Instructions Manual

INSTALLATION
INSTRUCTIONS
Over The Range
Microwave Oven
BEFORE YOU BEGIN
© Nig.@) S478 Save these instructions for local
inspector's use.
© ue) ea PN) Observe all governing codes and
coordinates.
+ NOTE TO INSTALLER - Be sure to leave these
instructions with the Consumer.
- NOTE TO CONSUMER - Keep these instructions for
future reference.
- SKILL LEVEL - Installation of this appliance requires
basic mechanical and electrical skills.
Read these instructions completely and carefully.
Proper installation is the responsibility of the installer.
Product failure due to improper installation is not covered
under the Warranty.
Please read all instructions thoroughly before installing
the Over the Range Microwave Oven. Two people are
recommended to install this product.
lf a new electrical outlet is required, its installation should
be completed by a qualified electrician before the Over the
Range Microwave Oven is installed. See 3 ELECTRICAL
GROUNDING INSTRUCTIONS on page 2.
MOUNTING SPACE
This Over the Range Microwave Oven requires a mounting
space on a wall as shown in Figure 1. Itis designed to be used
with standard 12" wall cabinets.
360" or more
Le from cooking
surface
| 66" or more
—— be
ee ee
Figure 1
WALL CONSTRUCTION
This Over the Range Microwave Oven should be mounted
against and supported by a flat vertical wall. The wall must be
flat for proper installation. If the wall is not flat, use spacers to
fill in the gaps. Wall construction should be a minimum of 2" x
4" wood studding and */s" or more thick dry wall or plaster/iath.
The mounting surfaces must be capable of supporting weight
of 110 pounds—the oven and contents—AND the weight of
all items which would normally be stored in the top cabinet
above the unit.
The unit should be attached to a minimum of one 2" x 4"
wall stud.
To find the location of the studs, one of the following methods
may be used:
A. Use a stud finder, a magnetic device which locates the
nails in the stud.
B. Use a hammer to tap lightly across the mounting surface
to find a solid sound. This will indicate stud location.
The center of the stud can be located by probing the wall with
a small nail to find the edges of the stud and then placing a
mark halfway between the edges. The center of any adjacent
studs will normally be 16" or 24" to either side of this mark.
NEED HELP?
For toll-free telephone support in the U.S. and Canada:
1-877-4ELECTROLUX (1-877-435-3287)
READ CAREFULLY. KEEP THESE INSTRUCTIONS.
P/N 316495050
TINSEB177WRRZ-EL81
Printed in Thailand