Audio Component Hookups - Sony STR-DE915 Operating Instructions Manual

This section describes how to connect AM and FM
antennas to the receiver. If you want to receive radio
broadcasts with the receiver, complete these
onnections first, then go to the following pages.
ANTENNA
hat antennas will ! need?
FM wire antenna
(supplied) (1)
* AM loop antenna
(supplied) (1)
M wire antenna Receiver AM loop antenna
ANTENNA
M
e If you have poor FM reception
Connect a 75-ohm coaxial cable (not supplied) to an FM
outdoor antenna.
ЕМ outdoor antenna
f) i
Receiver
\ | ANTENNA — )
Ground wire (not supplied)
To ground
Getting Started
Important
If you connect an outdoor antenna, ground it against
lightning. To prevent a gas explosion, do not connect
the ground wire to a gas pipe.
Notes
* Do not use h SIGNAL GND for this connection.
* To prevent noise pickup, keep the AM loop antenna away
from the receiver and TV.
ро с0а анаи RES END puma tiat СА
Audio Component Hookups
Overview
This section describes how to connect your audio
components to the receiver. If you want to use the
receiver as an amplifier, complete these connections.
Note for STR-DE915
For digital connections, see "Digital Component Hookups
(STR-DE915 only)" on page 10.
S-LINK CTRL A1
(STR-DE915/DE715 (USA, Canada) only)
PHONO CD DAT/MD TAPE
What cords will | need?
Audio cords (not supplied) (1 for each CD player and
turntable; 2 for each tape deck, DAT deck, or MD deck)
White (L) —— en. White (L)
Red (R) Red (R)
Hookups І
The arrow => indicates signal flow.
CD player
Receiver CD player
Tape deck
Receiver