Sealey LED3606R Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to instruction
manual
1. SAFETY
1.1. GENERAL
Ensure the light is fully charged before initial use.
9
DO NOT turn the light on when it is being charged.
8
DO NOT shine directly into your, other persons' or animals' eyes.
8
DO NOT allow children to use the light.
8
DO NOT handle or move the light whilst it is being charged.
8
DO NOT use the light if you suspect that the battery or the light casing is damaged.
8
DO NOT LEAVE BATTERY IN A DISCHARGED STATE, RECHARGE BATTERY IMMEDIATELY. BEFORE STORAGE,
8
FULLY RECHARGE THE BATTERY, SUBSEQUENTLY RECHARGE THE BATTERY AT LEAST ONCE EVERY SIX MONTHS
OF NON-USE.
1.2. BATTERY SAFETY
WARNING: To reduce the risk of burns or fire:
‰
DO NOT Attempt to open, dismantle, modify or service the battery pack.
8
DO NOT Crush, puncture, short external contacts or dispose of in fire or water.
8
DO NOT Expose to temperatures above 60°C (140°).
8
Replace only with the battery pack designated for this product.
9
Recycle or dispose of used battery as stipulated by local regulation.
9
If the electrolyte in the cells gets on your skin, wash thoroughly with soap and water. If it gets in your eyes, rinse thoroughly with cool
water and seek immediate medical attention.
2. INTRODUCTION
Unique and innovative 360° swivel and tilt function enables the light source to be positioned in any direction. Exclusive patented design
owned by and registered to Sealey. 15W SMD LED with magnified lens providing up to 1000 lumens output with 120° spread of light,
illuminating the whole work area. Includes an additional high power 3W LED directional torch. Features two swivel hooks and three
rubber covered magnets, two on the rear and one on the end, which allow hands-free operation. Two high quality 3.7V 2.6Ah lithium-
ion batteries in parallel for up to 15 hours run time. Micro USB charging port. Supplied with USB cable.
3. SPECIFICATION
Model No: LED3606 Red, Green
Battery: 3.7V 2.6Ah Li-ion (x2)
Charging Time: 7hr
IP Rating: IP54
LED Type: 15W + 3W SMD
Lumen Output: Side(High/Low)/Top - (1000/300)/150lm
Maximum Length: 276mm
Minimum Length: 256mm
Operating Time: Side(High/Low)/Top - (3/12)/15hr
4. OPERATION
4.1. CHARGING
4.1.1. To charge the light: insert the micro USB plug on the USB
cable into the charging port on the back of the light (fig.1).
4.1.2. Plug the other end of the USB cable into a 5V USB outlet.
4.1.3. The charge indicator lights (fig.1) will light in sequence to
show the current level of charge, each charge level being
shown by a flashing green before becoming solid.
© Jack Sealey Limited
360° 15W & 3W SMD LED RECHARGEABLE
INSPECTION LIGHTS
LED3606R, LED3606G
MODEL NO:
fig.1
Original Language Version
LED3606R, LED3606G Issue: 2 - (H,3) 22/09/23