Wiegand Reader Wiring - Honeywell MPA2C3 Installation Manual

Wiegand Reader Wiring

The RJ45 READER terminals can fully support an 8-wire cable (18-24 AWG). Pref-
erably use the standard FTP cable with RJ45 plug 8-wire CAT6E/7 (recommended)
8-conductor cable.
When using thicker cables (AWG18 - AWG20), an RJ45 -8 screw convertor (P/N:
MPA2RJ) is required to connect the reader to the panel.
For reader cable lengths and power requirements, please look in chapter xxxx.
Figure 3-16 The wire connections are listed below vs the orientation of the RJ45
connector.
Table 3-5 e wire connections are listed below vs the orientation of the RJ45 connector.
52
Reader wire
RJ45 PIN
Colour*
01 White
02 Green
03 Red
04 Black
05 Purple
06 Yellow
07 Orange
Blue
08
Pink
Wiegand Description
D1 D1 data signal from reader
D0 D0 data signal from reader
Reader power 12VDC from panel OR higher voltage from
12V
external power source**
GND Reader power 0V / GND
TMP Tamper from reader
BUZ Buzzer control from panel
GRN LED Green LED control from panel
Hold Hold wire (NOT NEEDED, but can be connected)
Arm Future use
MPA2C3 Installation Guide