Advertisement
The swivel vice
jaw can be locked in six
different 90°
positions
3
front facing and
3
rear facing.
To position the
swivelling vice jaw at
90°
remove the
wing nuts (A) and hexagonal
nuts (C) and
rotate cam lock (B) clockwise
through 45°.
Remove swivel
vice jaw and reposition in
one of the above
6 positions. Secure the
swivel vice jaw
following the above
procedure
in reverse order.
Note:
remember
to use the swivel
clamping
press location holes (D) fig. 1
Fig. 7 shows the centre board between the
two bottom cross frames as described in
fig. 4. Allowing for greater clamping
capacity.
NOTE: The adjustable vice jaw should
be removed or placed at the end of the
parallel rails.
Advertisement
