Lenovo 10HQ User Manual page 65

1. Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to the
computer.
2. Remove the computer cover. See "Removing the computer cover" on page 48.
3. Locate the storage drive. See "Computer components" on page 5.
4. Disconnect the signal cable and the power cable from the storage drive.
5. Remove the four screws that secure the storage drive. Slide the storage drive to the rear of the
computer, and then remove it from the computer.
Figure 18. Removing the storage drive
6. Slide the new storage drive into the storage drive bay to the front of the computer until the four screw
holes in the storage drive align with the corresponding screw holes in the chassis.
Figure 19. Installing the storage drive
7. Install the four screws to secure the storage drive to the chassis.
8. Connect the signal cable and the power cable to the new storage drive.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 63.
.
Chapter 7 Installing or replacing hardware
55