Specifying The Speaker Parameters - Sony HT-DDW750 Operating Instructions Manual

When pMcing surround speakers behind you
(wide room)
Sub wooer
\
Note
DO not place the center speaker further away from the
listening position than the front speaker.
Normal Speaker and Micro
Satellite Speaker
For HT-DDW750, the speaker size and the sub
woot_r selection has been preset to "MICRO
SP." (Micro Satellite Speaker) according to the
supplied speaker system.
When you select "MICRO SP.', the speaker
size _mdsub woofer selection has been
configuratedasfollows:
Speaker S_tings
FRONT SMALL
CENTER SMALL
SURROUND SMALL
SUB WOOFER YES
You cannot change the configuration if you
select "MICRO SP.'.
If you change the speaker system, select
"NORM. SP.'. You can adiust the speaker size
and sub woofer selection when you select
"NORM. SP." (page 17).
To select "NORM. SP.", turn off the power,
then turn on again while pressing MAIN
MENU. (To reset to "MICRO SP.", do the
same procedure.)
Tip
The seuing for Micro Salellite Speaker (MICRO SP.)
has been programmed to optimize the sotmd balance.
If you use Sow's Micro Satellite Speakers, select
"MICRO SP.".
Caution
When you use Micro Satellile Speakers and the
speaker size is set to "LARGE", you may not oblain
the corot soundstage. The speaker may also be
damaged at high volume position.
Specifying the speaker
parameters
1
Press MAIN MENU repeatedly to select
"<SET UP>".
2
Press MENU < or MENU > to select
the parameter you want to adjust.
3 Press MENU + or MENU - to select the
setting you want.
The setting is entered automatically.
4
Repeat steps 2 and 3 until you have set
all of the parameters that follow.
Initial settings
Parameter Initial setting
_ _ DIST. X.X rn (XX ft.)* 3.1) m (10 ft.)*
DIST. X.X m (XX ft.)* 3.0 m (10 ft.)*
i_ _ DIST. X.X m (XX fL)* 3.1) m (10 ft.)*
PL. x xxx LOW
* The default unit for models of area c_xle U, CA is
,,ft,,
The default unit for models of olher area code is
-m,,.
continued
,t-
o
a
€
W
€
lit
{a
'u
ID
w
OI
g
a
15 GB