Husqvarna DC 2-48 Operator's Manual page 15

3. Install the 2 compressor filters and close the 2 caps.
If you cannot fully clean the compressor filters or if they
are damaged, it is necessary to replace them.
To clean the filter in the water
separator
CAUTION:
washer to clean the filter. Do not hit the filter
with force to clean it.
1. Remove the filter in the water separator. Refer to
replace the filter in the water separator on page 15 .
2. Clean the filter with warm water.
3. Dry the filter with pressurized air.
4. Install the filter. Refer to
water separator on page 15 .
To replace the filter in the water separator
1. Stop the product. Refer to
page 11 .
2. Remove the bowl of the water separator (A).
3. Replace the filter of the water separator (B).
4. Install the bowl of the water separator (A).
To clean the primary filters
WARNING:
intake when the pulse cleaning cycle runs. If
the air intake is not closed, dust can come in
to the air. The dust particles are dangerous
to your health.
2121 - 002 - 04.07.2023
Do not use a high-pressure
To replace the filter in the
To stop the product on
B
A
Always close off the air
1. Start the compressor.
To
2. Start the motor for the rotating valves.
3. Keep the air compressor on for 30 minutes while
the product is not in operation. Pressurized air goes
through the primary filters and cleans them.
To replace the primary filters
WARNING:
protective equipment when you replace the
primary filters. Refer to
equipment on page 6 .
There are 20 primary filters in the product. Replace all
filters at the same time.
1. Stop the product. Refer to
page 11 .
Always use personal
Personal protective
To stop the product on
15