Sealey AK4402.V2 Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instruction protection
manual
1. SAFETY
WARNING! Ensure Health & Safety, local authority and general workshop practice regulations are adhered to when using this equipment.
‰
Familiarise yourself with the application and the limitations of the grease gun, as well as the potential hazards.
9
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
Keep the grease gun clean for best and safest performance.
9
Check moving parts alignment on a regular basis.
9
DO NOT use the grease gun for any purpose other than that it was designed for.
8
DO NOT operate the grease gun if any parts are damaged or missing, as this may cause failure and/or personal injury.
8
When not in use store in a safe, dry, childproof location.
9
WARNING! Always wear approved eye protection when operating the grease gun.
‰
WARNING! An empty grease cartridge or grease is under pressure from the spring in the barrel, use caution when removing it.
‰
WARNING! DO NOT apply excessive torque or over-tighten the grease gun head as this will apply undue stress to the die cast outlet and
‰
may cause it to fracture.
2. INTRODUCTION
Highly durable aluminium die-cast head with air release valve. Dual piston mechanism results in increased output per stroke. 3-Way
fill, with cartridge, bulk or suction. Accepts standard 400g cartridges. Supplied with 150mm bent steel extension delivery tube and
35mm coupler. Knurled grease tube and rubber handle for greater precision. Features variable stroke for controlled grease volume.
Dual inlet of grease ensures that the gun does not lose prime.
3. SPECIFICATION
Model No: ..................................................... AK4402.V2
Capacity: ............................500cm³ - 400cm³ Cartridges
Delivery per Stroke:............................................. 2.4cm³
Delivery Pressure: ............................................. 6000psi
Coupler
Extension pipe
Grease gun
head
Barrel
© Jack Sealey Limited
3-WAY FILL HEAVY-DUTY DUAL PISTON
GREASE GUN
MODEL NO:
Wear
Wear
protective
protective
clothing
gloves
Bleed valve
Plunger rod handle
Original Language Version
AK4402.V2
Heavy duty lever
handle
fig.1
Plunger rod tab
fig.2
AK4402.V2 Issue:1 03/07/23