Table of Contents
Advertisement
3-8. PINCH ARM ASSEMBLY, TG-7 ASSEMBLY
1.
Removal (See Fig. 3-8.)
2. Installation (See Fig. 3-8.)
1) Set the [B] mode.
1) Grease the inner surfaces of hole @ (See Fig. A).
2) Remove the stopper washer @ , then remove the pinch arm
2) Insert the axle @ of the TG-7 arm assembly @ into the
assembly @.
hole @.
3)
Bend the claw @ inside hole @ in the direction of the arrow
3) Grease the shaded section @ (See Fig. A).
using a thin screwdriver or the like, then remove the TG-7
4) Insert the TG-7 plate spring @ into the hole @, then secure
plate spring @.
it with the claw @.
4) Remove the TG-7 arm assembly @.
5) Apply half a drop of oil to the axle @ (See Fig. B).
6) Fit the pinch arm assembly @ to the axle @ and insert the
pinch roller sub arm assembly tab @ into the ® part.
7)
Install the stopper washer @.
Note:
© Take care not to grease the screw €D of the TG-7 arm
assembly @ (See Fig. A).
© When fitting the pinch arm assembly @ to the axle
©, make sure that it does not touch the TG-7 guide
@ or the rubber roller ®.
¢ After assembling, be sure to perform tape path
adjustment as described in section 4.
© TG-7 Plate Spring
@® Rubber Roller
@ Stopper Washer
® TG-7 Guide
e
'Arm
Assembly
© 1G-7 Arm Assembly
@ Axle
©
@ Screw
Ch
© 1G-7 Arm Assembly aa
|
Fig. A
«f
© Axle
Claw
Haltadrop}
®
of oil
Fig. B
Advertisement
Table of Contents
