■
Lift range back panel up and off.
■
Use Phillips screwdriver to remove screws and slide
cord/conduit plate down and out.
■
Position cord/conduit plate as shown in the following
illustration.
■
Replace cord/conduit plate and insert screws.
E TAG!
E TAG!
USE
CORD
CORD
USE
CORD
REMOV
WITH
WITH
REMOV
WITH
POWER
POWER
POWER
ETIQUE
ETIQUE
AS
TA
TA
NUTS
NUTS
NUTS
QUITE
USE
QUITE
LA
LAS
CONEC
LA
CONEC
TAR
TAR
TUERC
ICO
EL
EL
ICO
PARA
CORDÓ
PARA
CORDÓ
N ELÉCTR
N ELÉCTR
■
Assemble a UL listed conduit connector in the opening.
A. Removable retaining nut
B. Strain relief
■
Feed the flexible conduit through the strain relief, allowing
enough slack to easily attach wiring to the terminal block.
■
Tighten strain relief screw against the flexible conduit.
5. Replace back panel and screws on rear of range.
6. Complete installation following instructions for your type of
electrical connection:
4-wire (recommended)
3-wire (if 4-wire is not available)
Electrical Connection Options
If your home has:
And you will be
connecting to:
4-wire receptacle
A UL listed,
(NEMA type 14-50R)
250-volt
minimum,
40-amp, range
power supply
cord
4-wire direct
A fused
disconnect or
circuit breaker
5"
box
(12.7 cm)
3-wire receptacle
A UL listed,
(NEMA type 10-50R)
250-volt
minimum,
40-amp, range
power supply
cord
3-wire direct
A fused
disconnect or
1"
(2.5 cm)
circuit breaker
box
3"
(7.6 cm)
A
B
Go to Section:
4-wire connection:
Power supply cord
4-wire connection:
Direct wire
3-wire connection:
Power supply cord
3-wire connection:
Direct wire
7