Table of Contents
Advertisement
Label Distribution Protocol
5.8 LDP Configuration Overview
When the 7705 SAR implementation of LDP is instantiated, the protocol is in the no
shutdown state. In addition, targeted sessions are then enabled. The default
parameters for LDP are set to the documented values for targeted sessions in
draft-ietf-mpls-ldp-mib-09.txt.
LDP must be enabled in order for signaling to be used to obtain the ingress and
egress labels in frames transmitted and received on the service destination point
(SDP). When signaling is off, labels must be manually configured when the SDP is
bound to a service.
430
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com
MPLS Guide
3HE 18686 AAAB TQZZA
Advertisement
Table of Contents
