Sealey MS087 Manual

thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instruction protection
manual
1. sAFety
WArNING! Take extreme caution when using this appliance, compressed air can cause serious injury.
‰
Keep out of reach of children. This product is not for sale to under 18's.
9
Cartridges freeze on discharge, use the supplied insulation sleeve.
9
maintain the adaptor in good and clean condition for best and safest performance.
9
When not in use, clean and return to the wallet complete.
9
Wear eye protection.
9
Use cartridges with supplied adaptor only.
9
Do Not discharge near face or body.
8
Do Not use this appliance for any purpose other than that for which it has been designed.
8
Do Not pierce the compressed air cartridges, other than in the supplied adaptor fully fitted to the tyre valve.
8
Do Not unscrew from the adaptor until the cartridge is fully discharged.
8
Do Not use the adaptor if damaged.
8
Do Not expose the charged cartridges to direct sunlight or temperatures above 49°C (120°F). Danger of explosion.
8
Do Not dispose of charged cartridge.
8
Do Not take charged cartridges on board an aeroplane.
8
WArNING! the warnings, cautions and instructions in this manual cannot cover all possible conditions and situations that
‰
may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into
this product, but must be applied by the operator.
2. INtroDUctIoN
CO2 tyre inflator kit including adaptor for Schrader type valves (used by most cars and motorcycles and some bicycles). Includes 2 x 16g
canisters of CO2. Supplied in zipped storage pouch.
3. coNteNts
Item Description
1 Adaptor
2 CO Cartridge
2
3 Insulation Sleeve
4 Zipped Pouch (not shown)
4. oPerAtIoN
4.1. Ensure the adaptor (1) valve is closed; fit the knurled nut to the "Schrader" valve of a tubed deflated tyre. Wind the knurled nut of the
adaptor fully until tight.
4.2. Place the insulation sleeve (3) over a charged cartridge (2) and screw the sleeved cartridge into the adaptor port.
4.3.
Screw the sleeved cartridge into the adaptor port, full depth.
4.4. The cartridge will discharge the CO
4.5. With caution, unscrew the sleeved cartridge slowly to ensure the cartridge is fully discharged safely.
4.6. If required repeat 4.1.,4.2., 4.3. and 4.4.
© Jack Sealey Limited
motorcycle co2 emerGeNcy tyre
INFlAtor KIt
ms087
mODEL NO:
Qty
1
2
1
1
into the tubed tyre, controlled by opening the adaptor valve anticlockwise.
2
Original Language Version
2
Valve, turn fully
1
clockwise to close.
Knurled nut
3
mS087 | Issue:2 (H,F) 16/07/19