Advertisement
LM Series Hz
Instructions - Right-Hand Unit: End Blow
and Straight Through (LM0**-HZ-*R*-**)
1. Remove and retain end and side
panels.(Figure#17)
Figure # 17
2. Disconnect blower motor wiring and ground
wire fastened to blower housing.(Figure#18)
Figure # 18
3. Remove and retain (4) screws under the
blower collar. (Figure #19)
Figure # 19
4. Slide blower assembly away from mounting
bracket. (Figure #20)
Revised 07-13
Air coil is in close proximity to the blower.
Air coil fins are easily damaged. Great care
must be taken during this step to avoid coil
damage. Shipping cardboard can be used as
protection during blower removal and
installation.
.
Figure # 20
5. Remove and retain (1) vertical bracket by
removing (2) screws. (Figure #21)
Figure # 21
Horizontal Units | 7
8 733 911 121 (2013/7)
Advertisement
