Installation - AEG S53520CTX2 User Manual

14 www.aeg.com
Problem
Temperature cannot be set.
Door is misaligned or inter-
feres with ventilation grill.
The temperature in the ap-
pliance is too low/too high.
8.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to

"Installation".

3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
9. INSTALLATION
9.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
WARNING!
Refer to Safety chapters.
Possible cause
The FROSTMATIC or COOL-
MATIC function is switched
on.
The appliance is not level-
led.
The temperature regulator is
not set correctly.
The door is not closed cor-
rectly.
The food products' tempera-
ture is too high.
Many food products are
stored at the same time.
The door has been opened
often.
The FROSTMATIC function
is switched on.
There is no cold air circula-
tion in the appliance.
8.3 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service
Center .
class indicated on the rating plate of the
appliance:
Climate
class
SN
Solution
Switch off FROSTMATIC or
COOLMATIC manually, or
wait until the function resets
automatically to set the tem-
perature. Refer to "FROST-
MATIC or COOLMATIC
function".
Refer to "Levelling".
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if neces-
sary.
Refer to "FROSTMATIC
function".
Make sure that there is cold
air circulation in the appli-
ance.
Ambient temperature
+10°C to + 32°C