Advertisement
APPLICATION:
The Trim Line Awning is designed and intended for mount-
ing on pop-up tent trailers and pickup campers.
Read the entire installation procedure
IMPORTANT:
before starting the installation.
NOTE:
The Dometic Corporation assumes no liability for
damages or injury resulting from installation or operation of
this product.
l.A.
Install vinyl welt of awning bag into awning rail by
inserting vinyl welt into one end of awning rail and
sliding awning into position. (See FIG. 1 .A)
B.
If the awning is to be left mounted during travel,
secure each end by drilling a 7/64" diameter hole and
installing a #6x 5/8" sheet metal screw in each end.
(See FIG. 1 .B)
NOTE: If the awning is installed above the door, Door
Roller Kit (Part No. 930004) may be installed to prevent
damage to fabric.
FIG. 1A
FIG.
4
I
Tie Strap
NOTE:
When unzipping bag or untieing poles, be sure
to hold poles so loose poles do not fall out of the
bag.
2.
Unzip bag and untie and remove poles from bag.
3.
Undo velcro strap and unroll awning fabric.
4.
Insert pin of rafter pole through the eye of the
adjustable pole and through hole on the roller tube.
(See FIG. 4).
5.
Repeat Step 4 on the other side of the awning.
6.
Compress the rafter pole and place the end of the
rafter against the side of the camper, directly under
the edge of the fabric. (See FIG. 6)
7.
Repeat Step 6 on the other side of the awning.
6.
To raise awning, twist lower adjustable pole while
holding upper pole and raise awning to desired
height. Twist lower pole to lock in position. (See FIG.
NOTE:
8).
If application requires longer adjustable
poles, order Kit No. 3104264.001 from your Dealer.
NOTE:
The wire tie-down loops are provided in
the adjustable poles if you desire to tie the awning
down to tent stakes (provided in the hardware bag).
9.
To close awning, reverse Steps 2 through 8. )NOTE:
During rain, awning should be closed or one end
lowered to allow water to run off.
10.
After rolling up the awning fabric, use velcro strap to
hold awning in place while storing the poles. Zip one
end of the bag 1/3 closed and slide the poles into that
end of the bag. Now tie the free end of the poles with
the end tie strap. Now unzip the bag and tie the other
end strap. Zip the bag closed.
I
Tie Strap
Stake
Advertisement
