Table of Contents
Advertisement
4
en | Safety and security information
1
Safety and security information
Read, follow, and retain for future reference all of the following safety instructions. Follow
all warnings before operating the device.
1.1
Safety precautions
Caution!
Installation should only be performed by qualified service personnel in accordance with the
!
National Electrical Code (NEC 800 CEC Section 60) or applicable local codes.
1.2
Important safety instructions
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
2023-10 | 01 |
To clean the device, do not use liquid cleaners or aerosol cleaners.
Do not install the device near any heat sources such as radiators, heaters, stoves, or
other equipment (including amplifiers) that produce heat.
Do not spill liquids on the device before installation is completed.
Take precautions to protect the device from power and lightning surges.
Adjust only those controls specified in the operating instructions.
Operate the device only from the type of power source indicated on the label.
Unless qualified, do not attempt to service a damaged device yourself. Refer all
servicing to qualified service personnel.
Install in accordance with the manufacturer's instructions in accordance with
applicable local codes.
Use only attachments/accessories specified by the manufacturer.
Protect all connection cables from possible damage, particularly at connection points.
Use STP Category 5e (or higher) cable with RJ45 connectors.
When using a Class I adapter with your product, the power cord shall be connected to
a socket-outlet with a connection to ground.
The Low Voltage power supply unit used must comply with EN 62368-1.
For PoE connections, the adapter shall be rated 48 VDC, 0.30 A minimum and a
temperature specification up-to and including 50ºC / 122ºF
For AC/DC connections, the adapter shall have the following requirements:
–
the adapter shall be rated 12 VDC, 1.12 A minimum; or
–
the adapter shall be rated 24 VAC, 50/60 Hz, 0.80 A minimum
–
the adapter specification shall cover temperatures up-to and including 50ºC /
122ºF
Your product shall only be connected to PoE networks without routing to the outside
plant.
When your product is powered by a power adapter, the adapter shall be powered by a
Listed Power Adapter, or DC power source, marked L.P.S. - Limited Power Source.
To install the terminal block, the following is required:
–
Wiring should be installed and connected by certified professionals.
–
Usage of the appropriate wire for terminal block: AWG 24~20, Cu type wire, FW2
–
To install the wire to the terminal block: Insert and clamp.
Installation Manual
FLEXIDOME corner 7100i IR
Bosch Security Systems
Advertisement
Table of Contents
