Table of Contents
Advertisement
40
en | Configuration
4.5.8
SD Card Status
This section identifies the details about the SD card installed in the device:
–
–
–
–
–
For non-industrial SD cards, the lifespan options are not available.
Lifespan check
When checked, the Lifespan status is shown in the details of the SD cards.
Lifespan alarm
Set the alarm warning to a defined percentage of the lifespan. The alarms can be given as:
–
–
–
If a SD card is not installed, 'SD card not found' is shown.
Notice!
i
Bosch recommends the use of industrial micro SD cards with health monitoring.
4.6
Alarm
4.6.1
Alarm Connections
In the event of an alarm, the unit can automatically connect to a pre-defined IP address. The
unit can contact up to ten IP addresses in the order listed until a connection is made.
Connect on alarm
Select On so that the unit automatically connects to a pre-defined IP address in the event of
an alarm.
Select Follows input 1 so that the unit maintains the connection for as long as an alarm
exists on alarm input 1.
Auto-connect
Select On to automatically re-establish a connection to one of the previously specified IP
addresses after each reboot, connection breakdown, or network failure.
Number of destination IP address
Specify the numbers of the IP addresses to be contacted in the event of an alarm. The unit
contacts the remote locations one after the other in the numbered sequence until a
connection is made.
Destination IP address
For each number, enter the corresponding IP address for the desired remote station.
Destination password
If the remote station is password protected, enter the password here.
Only ten passwords can be defined here. Define a general password if more than ten
connections are required. The unit connects to all remote stations protected by the same
general password. To define a general password:
1.
2.
3.
2023-10 | V02 | F.01U.407.683
Manufacturer
Product
Size
State
Lifespan.
An audio alarm
An e-mail
A warning through the Video Management System
Select 10 in the Number of destination IP address list box.
Enter 0.0.0.0 in the Destination IP address field.
Enter the password in the Destination password field.
User Manual
FLEXIDOME corner 7100i IR
Bosch Security Systems
Advertisement
Table of Contents
