Table of Contents
Advertisement
FPT-DACT | Operation & Installation Guide |
5.0
Programming
5.1
Using the Keypad
All programming for the FPT-DACT is done using the FMR-DACT-KEYPAD. To properly program the FPT-
DACT, you must always press the [* Command] and [* Clear] keys in addition to the key(s) necessary to make
specific programming entries.
•
Press [# Command] to accept an entry into the FPT-DACT.
•
Press [* Clear] after pressing [* Command] to return to the submenu or menu selections.
Refer to Figure 24 for the complete programming key sequence for setting the FPT-DACT operational date.
Figure 24: Programming Key Sequence for System Date
0
Program
1
1 - Press [0 Program] to enter the Programming to [9].
2 - Press [1] to enter the Prog Time Submenu.
3 - Press [1] again to select SYSTEM for the system date and time.
4 - Enter the current date using the keypad keys [0] Mode Menu.
5 - Press [# Command] to enter the date into the system.
6 - Press [* Clear] to move to the next menu item, or to return to previous menus.
Once you enter the Programming Menu (Level 2), you no longer need to press [0] to re-enter the
Programming Menu. If you press [0] while already in the Programming Menu, the keypad emits a
three-beep error tone.
When Programming Mode is entered, all monitoring ceases. The FPT-DACT does not process input
point events, supervise the phone lines, or monitor the serial link. The central station communication is
disabled.
1/05 | F01U002505B
5.0 Programming
ENTER DATE
1
1
MMDDYY: 010100
2
3
#
Command
5
4
EN | 28
*
Clear
6
Advertisement
Table of Contents
