How To Connect The Pc Input Terminals - Panasonic TU-PTA500U Operating Instructions Manual

Installation
How to connect the PC Input Terminals
Computer
\
I 1
Conversion adapter (if necessary)
RGB
PC cable
"_k (_m_onnect a cable which matches the
audio output terminal on the computer.
D-sub 15p
O
1/8"(3 mm)stereo plug
Notes:
(1) Computer signals which can be input are those with a horizontal scanning frequency of 15.5 to 110 kHz and vertical
scanning frequency of 48 to 120 Hz. (However, signals exceeding 1200 lines will not be displayed properly.)
(2) The display resolution is a maximum of 640 x 480 dots when the aspect mode is set to "NORMAL", and 852 x 480
dots when the aspect mode is set to "FULL". If the display resolution exceeds these maximums, it may not be
possible to show fine detail with sufficient clarity.
(3) Some PC models cannot be connected to the set.
(4) An adapter is required to use the PC cable (D-sub 15P) to connect a Macintosh computer to the set.
(5) There is no need to use an adapter for computers with DOSN compatible D-sub 15P terminal.
(6) The computer shown in the illustration is for example purposes only.
(7) Additional equipment and cables shown are not supplied with this set.
(8) Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specified
frequency range.
Signal Names for D-sub 15P Connector
Pin layout for PC input
terminal
Pin No.
®
®
®
®
Signal Name
R
G
B
GND (Ground)
GND (Ground)
Pin No,
®
®
®
®
@
Signal Name
GND (Ground)
GND (Ground)
GND (Ground)
NC (not connected)
GND (Ground)
Pin No.
@
@
@
@
@
Signal Name
GND (Ground)
NC
HD / SYNC
VD
NC
14