TA-AX500
SECTION
3
ADJUSTMENTS
3-1.
ELECTRICAL
ADJUSTMENTS
Note:
1, DC
BIAS and DC BALANCE adjustments should
be made several minutes after the POWER
switch
is turned on (POWER
ON.).
2. Make DC BIAS adjustment first.
DC Bias Adjustment (with no signal input)
Procedure:
Adjust RT301
(L-CH) and RT351 (R-CH) for 5 mV
reading on the VOM.
Adjustment Location:
— L-CH —
VOM
(DC range)
RT301 (L-CH)
3. Repeat DC BIAS and DC BALANCE
adjustments
two or three times.
4. After replacing the power
transistor, DC
BIAS
and DC BALANCE
adjustment should be made.
VOM
(DC range)
RT351 (R-CH)