Starting Operation - Bosch PSR Select Original Instructions Manual

32 | English
Operation

Starting Operation

Set the rotational direction (see figure E)
The rotational direction switch (8) is used to change the rotational direction
of the power tool. However, this is not possible while the on/off switch (10)
is being pressed.
Right rotation: To drill and to drive in screws, press the rotational direction
switch (8) through to the left stop.
The rotational direction indicator for right rotation (4) lights up
when the on/off switch (10) is pressed and the motor is run-
ning.
Left Rotation: To loosen and unscrew screws and nuts, press the rotational
direction switch (8) through to the right stop.
The rotational direction indicator for left rotation (6) lights up
when the on/off switch (10) is pressed and the motor is run-
ning.
Switching on/off
Note: The power tool can only be switched on if the sliding switch (7) has
been pushed forwards.
To start the power tool, press and hold the on/off switch (10).
The lamp (12) lights up when the on/off switch (10) is lightly or fully
pressed, meaning that the work area is illuminated in poor lighting condi-
tions.
To switch off the power tool, release the on/off switch (10).
The drill spindle is locked when the on/off switch (10) is not pressed.
If the drill spindle is blocked, do not press the on/off switch for longer
than 15 seconds. The power tool may become damaged if you do this.
Battery charge-control indicator
The battery charge indicator (5) displays the state of charge of the battery
when the power tool is switched on.
LED
Green continuous light
1 609 92A 84N | (21.07.2022)
Capacity
≥ 30%
Bosch Power Tools