Table of Contents
Advertisement
Camera Setup
Set up factory-set remote cameras connected to the network in one go.
Setting item
Search
Target Camera
Administrator Name
Password
IPv4 Setting Method
Confirm Password
IPv4 Address
Subnet Mask
Default Gateway
Apply
Network
Perform the device's network settings.
Setting item
IPv4 Setting Method
IPv4 Address
Subnet Mask
Default Gateway
Apply
IPv6 Address
Prefix Length
Default Gateway
Apply
Application Control
User Name
Password
Controller Name
Setting values/description
Searches for factory-set cameras among cameras on the same network. Found
cameras are reflected in the [Target Camera] list.
When setting up only one camera, selects the camera to be set up from the factory-
set cameras found using [Search].
Inputs the administrator name to be set for the camera (5 to 15 alphanumeric
characters and symbols).
Inputs the password to be set for the camera (8 to 32 characters – must contain two
of the following: letters, numbers or symbols).
Auto (DHCP), Manual
Selects an IPv4 address setting method.
Inputs the password for verification.
0.0.0.0 to 255.255.255.255
Inputs the starting IPv4 address.
Inputs the subnet mask.
Inputs the default gateway. If 0.0.0.0 is input, it will be set to "none".
Sets up the camera selected in [Target Camera] or all found cameras at once. For all
found cameras, if [IPv4 Settings Method] is [Manual], the IP addresses of the second
and subsequent cameras are set in order by adding 1 (or more) to the address set in
[IPv4 Address].
Setting values/description
DHCP / AutoIP, Manual
Selects an IPv4 address setting method.
0.0.0.0 to 255.255.255.255 (192.168.100.254)
Inputs the IPv4 address.
0.0.0.0 to 255.255.255.255 (255.255.255.0)
Inputs the subnet mask.
0.0.0.0 to 255.255.255.255 (0.0.0.0)
Inputs the default gateway address.
Saves the device's IPv4 address settings.
Inputs the IPv6 address (up to 39 lowercase letters, numbers and ":").
16 to 128 (64)
Inputs the IPv6 prefix length.
Inputs the IPv6 default gateway address (up to 39 lowercase letters, numbers and
":").
Saves the device's IPv6 address settings.
HTTPS, HTTP/HTTPS, Off
Selects whether to allow control of the controller from an external device and the
available communication protocol.
Inputs the device's user name (5-15 alphanumeric characters or symbols) when
accessing from an external device.
Inputs the device's password (8 to 32 characters – at least two character classes
from letters, numbers or symbols are required) for access from an external device.
Up to 15 alphanumeric characters/symbols (Controller).
Inputs the controller name.
Advertisement
Table of Contents
