Disassembly Procedure - HP 8481A Operating And Service Manual

08481-90049
3 A
Disassembly
Procedure
Caution
Note
$
HP 8481 A/82 A
/8
Disassemble the Power Sensor by performing the following steps:
Disassembly must be performed in sequence described bH-77-~
A""' "■
L Si;tk, , 2
5
8i""
(See figure 9.) sensor. Gently pry the sections apart.
2. Proceed to the other side of the connect™- ,„i „ •
sections apart. Remove the shells and magnetic Sd^
'■ ss Kxfiri
"'S"
tsr8
(*->■ —w.
alien cap screws 1 t ^ mput connectOT- Remove the
upper chassis from tie Power SensoT" " "d ^ Rem°Ve
come from the BtUkh^As^embTy" 7 ^ ^ **" S°W Ieads wWch
5- Remove cap screws 3, 4, and
5
.
6. Slide the Bulkhead Assembly straight out from the chassis.
7. Remove cap screws
8
, 9,
11
, i2,
14
, and 15.
8- Lift the A2 Input Amplifier and Jl connector out of the chassis.
24