Advertisement
Using fabric conditioners
When you want to use a conditioner, put
the measured amount (follow
manufacturers' instructions) into
compartment «c» in the washing powder
dispenser at the same time as you put in
the washing powder. Be careful not to
fill the compartment above the level of
the filter. The conditioner will be
automatically used by the machine at the
appropriate time. Remember to close the
drawer gently (see above).
To start the machine
Check that:
the main switch is on;
the door is properly closed;
the water is turned on.
Select the programme required by
pushing in the programme selector dial
and turning it clockwise to the required
letter. Press in the on/off pushbutton and
the machine will start. When selecting
the drying cycle, you also have to set the
required drying time by turning the
selector dial. The machine will
automatically carry out all the operations
up to the end of the chosen programme.
Then it will stop.
If, after the start of a programme, you
find you have selected the wrong one,
push the on/off button in to stop the
machine. Then turn the dial clockwise to
the correct position and press the on/off
button again to restart the washing cycle.
At the end of the programme push the
same button in to switch the machine off.
Unloading the clothes
The drum door remains automatically
locked for 1-2 minutes after the machine
has been switched off. You can then open
the door and unload the machine. If you
have been using a gentle wash cycle do
not forget to set the machine to drain
the water (programme Q or R) before
opening the door.
Additional programmes
Spin only
This programme can be used to remove
water from hand washed articles or any
laundry which may have got wet but does
not need washing. For example, washing
left on the line during a rainstorm. See
pages 17 and 19.
Special treatments
If you want to treat an article with fabric
conditioner without washing it first, you
can choose programme F or P, according
to the fabric.
24
Advertisement
