Setting Of Dip Switches And Rsw Switches - Hitachi YUTAKI M RASM-3WF2E Installation And Operation Manual

6.2 Setting of DIP switches and RSW switches


NOTE
• The mark "■" indicates the DIP switches positions.
• No mark "■" indicates pin position is not affected.
• The figures show the settings before shipment or after selection.
• "Not used" means that the pin must not be changed. A malfunction might occur if changed.
!
CAUTION
Before setting DIP switches, first turn the power supply OFF and then set the position of DIP
switches. If the switches are set without turning the power supply OFF, the contents of the setting
are invalid.
The PCB in the outdoor unit is operating with DIP switches and push switches. The location is as
follows:
6
Refrigerant cycle Water cycle
50
PMEN0657 rev.0 - 02/2024