Table of Contents
Advertisement
Mechanical Parts
Parts Name
Removing Step
i
Remarks
Motor ass'y
1. Desolder the motor wires.
2. Remove the capstan belt.
3. Remove 3 screws of the motor.
[9]
11
Flywheel
1. Remove the capstan belt.
When replace the flywheel,
2. Remove 1 screw fastening the flywheel
forget to insert the nylon
holder.
washer to the shaft of
3. Pull out the flywheel.
flywheel.
Pinch roller arm ass'y
1. Remove "E" ring holding the pinch roller
arm ass'y.
2. Pull out it from the shaft.
Take up reel ass'y
1. Remove 2 screws fastening the cassette
holder plate.
2. Remove the countor belt.
3. Remove "E" ring holding the take up
reel ass'y.
4, Pull out it from the shaft.
Supply reel ass'y
1. Remove 2 screws fastening the cassette
holder plate.
2. Remove "E" ring holding plate.
3. Pull out it from the shaft.
Note;
1. Don't dirty, slippery and undue run-out the capstan belt and the counter belt.
2. Adjust height of the motor pulley, when the capstan belt connect to the flywheel from the motor pulley, so that
it will be parallel the chassis.
Fig. 10
Fig. 9
CD-1740/A/B/E/U
No. 4133
= 6
Advertisement
Table of Contents
