Table of Contents
Advertisement
Available languages
Available languages
-€lL-
Anti-Theft Svst
§ \nti- Nei
OVS LEM
continued
@) As shown in Fig.3, insert the removable face plate with the arrow pointing toward the removable face plate
case until you hear a "click". Keep the removable face plate in the case. Then, you can bring the plate safe-
ly.
@ Removable
Face Plate Case
To install the Removable Face Plate
( Slide the left side of the removable face plate in place.
Removable Fate Piate
Cutout
Fig.4
~ Installat
. The car's dashboard should have a thickness of
n
Preparation
® Before installation check the radio operation with antenna and speakers.
e Disconnect the cable from the negative (—) battery terminal (see caution below).
Caution:
For installation to cars with trip or navigational computers, all electronic memory settings previously registered
in the computer will be lost when the battery terminal is disconnected. For this type of car, battery could not be
disconnected. Therefore, extra care should be taken to prevent short circuiting.
In-dash Installation
Installation Opening
In-dash installation can be done if the car's dash-
board has an opening for this unit as shown in Fig. 1.
4.5mm - 6mm in order to make the installation of the
| <
:
.
182 mm
unit.
Fig. 1
Installation Precautions
This equipment, If possible, should be installed by a professional installer.
tn case of difficulty, please consult your nearest authorized Panasonic Service Center.
1. This system Is to be used only in a 12-volt, DC battery system (car) with negative ground,
2. Follow the electrical connection on page 35 carefully. Failure to do so may result in damage to the unit.
3. Connect the power lead after other connections are made.
4, Be sure to connect the YELLOW lead to the positive terminal (+) of the battery or fuse block (BAT) terminal.
5. Insulate all exposed wires to prevent short circuiting.
6. Secure all loose wires after installing the unit.
7. Please carefully read the operating and installation instructions of the respective equipment before connect-
Ing it to this unit.
Supplied Hardwares
© Mounting Collar
Plain Washer (5 mm¢)
Spring Washer (5 mmo)
8
) | Mounting Bolt (5 mmo)
'§: | Dismounting Pin
J
1
Hex. Nut (6 mmé)
Rear Support Strap
®
Hex. Bolt
(5 mmo x 25 mm)
NA TSEPd
NA1S
Advertisement
Table of Contents
