Hitachi air home 300 Operation Manual page 8

ATTACHING THE AIR PURIFYING FILTERS
CAUTION
!
Before cleaning, stop operation and switch off the power supply.
1
Open the front panel
Pull up the front panel by holding it at both
●
sides with both hands.
2
Remove the Pre-fi lter
Push upward to release the claws and pull out
●
the Pre-fi lter.
3
Attaching the air purifying fi lters
Attach the air purifying fi lters to the C-case
●
by gently inserting from the either side and
securely fi tted as shown in diagram. Do not
bend the frame or edge of the fi lters.
Bring the C-case to the back side of the pre-
●
fi lter. Insert it claws on left and right to the
C-case fi xing slot securely.
! CAUTION
Do not bend the air purifying
fi lter as it may cause damage
to the structure.
Please do not smell direct from
source of fi lter.
4
Attach the Pre-fi lters
Attach the Pre-fi lters by ensuring that the surface
●
written "FRONT" is facing front.
After attaching the Pre-fi lters, push the front panel
●
at three arrow portions as shown in fi gure and
close it.
NOTE
In case of removing the air purifying fi lters, please follow the above procedures.
●
The cooling capacity is slightly weakened and the cooling speed becomes slower when the air purifying
●
fi lters are used. So, set the fan speed to "HIGH" when using it in this condition.
Air purifying fi lters are not washable. It is recommended to use vacuum to clean it. It can be use for
●
1 year time. Type number for this air purifying fi lter is <SPX-CFH22VR>. Please use this number for
ordering when you want to renew it.
Pre-fi lter
C-case fi xing slot
Claw
– 8 –
Air purifying fi lter
Insert the air
purifying fi lter
C-case